Olimpia splendid PELER 8 Instructions Pour L'installation, L'emploi Et L'entretien page 52

3.4.c - Oscillation key (A6-A7)
When the ON button is pressed (A1), the horizontal flaps (10) will open automatically.
- Press the button (A7) and the horizontal flaps (10) will oscillate. Press the
button again and the flaps will stop at the desired position.
Press it again and the flaps will resume their oscillation.
- Press the button (A6) and the vertical flaps (11) will oscillate and the LED (B10)
will light up. Press it again and the vertical flaps will resume their oscillation.
Press the OFF button (A1) and the horizontal flaps (10) will close.
3.4.d - Mode key (A2)
When the appliance is switched on, "normal" mode is set by default.
Press this key and the mode changes according to this sequence:
Normal ---> Natural ---> Sleep (sleeping) ---> Normal ---> Natural ---> ...
The mode LED changes accordingly (the "natural" (B6) and "sleep" (B7) modes
are not available at "silent" speed (B8)).
The various modes work as follows:
1 - Normal (B6): the appliance works constantly at the set speed.
2 - Natural (B7): the appliance works changing air speed continuous-
3 - Sleep (B8):
3.4.e - Timer key (A4)
When the appliance is on, press this key and the timer changes according to
this sequence:
0h (off) ---> 1h ---> 2h ---> 3h ---> .. 12h ---> 0h (off) --->
ly.
the appliance works changing air speed continuous-
ly, reducing it down to the minimum value.
..
EN - 18
PELER 8