Publicité
Les langues disponibles
Les langues disponibles
10. Tips: Mark the start of grinding e.g. with a piece of chalk and grind all the teeth in one direction,
then turn the clamping screw (mind the angle) and grind the teeth in opposite direction.
With worn chains, the lateral guide position shall be set for the grinding disk not to touch the guide.
Avoid any strong thrust as the teeth might collide and the chain would wear and tear too fast
Watch out for the sharpening angle to correspond to the guides' position.
The type of the chain to be sharpened should be determined using the table.1. There, you can find out
the cutting thickness, angles and dimensions.
11. Note: Never grind any driven parts.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, ensure that product is disconnected from its
power source.
6.1- Cleansing
Clean plastic parts with a soft and clean cloth
Do not use aggressive cleansers (solvents or abrasive cleansers), or an abrasive sponge.
Do not use any caustic to clean the plastic parts.
Do not put or immerse tool in water or any other liquid, and ensure that no water gets inside the tool.
Clean ventilations holes with a soft brush or with compressed air.
6.2- Changing the grinding disk
1. Disconnect machine from its power source.
2. Remove lateral disk guard.
3. Remove disk flange
4. Remove used disk and fit a new grinding disk (refer to dimension characteristics)
5. Fit the disk flange and tighten screw.
6. Replace additional disk guard.
7. Ensure that the whole assembly is tight.
8. Warning! Do NOT use grinding wheels that are worn, broken, cracked or damaged.
Use only original grinding wheels or grinding wheels recommended by tool manufacturer.
6.3- Service
a) Have your tool serviced by a qualified repair person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
b) Have your tool repaired by a qualified person
Unless otherwise indicated in this instruction manual, repairs or replacement of any damaged part in
an authorised service centre is recommended.
This electric tool is in accordance with the relevant safety requirements. Repairs should only be
carried out by qualified persons using original spare parts; otherwise this may result in considerable
danger to the user.
c) Maintain tool with care
Keep tool clean for better and safer performance.
d) Storage
- Store product, instructions manual and accessories in its original packaging.
- Product must be stored in a clean, dry location. Always lock up product and keep out of reach of
children
Page 20 of 32
Publicité
