Publicité
Les langues disponibles
Les langues disponibles
4.6.2- Setting the grinding angle
Set the top rotary table (8) angle by means of the setting wheel (6) (see Fig.6).
Loosen the setting wheel (6).
Set to desired grinding angle, which can be read on the scale (7).
Tighten the setting wheel (6).
The rotary table angle can be adjusted 35° to the right or to the left.
4.6.3- Setting the grinding depth (Fig.7)
Loosen the setting wheel (3).
Lower the grinding disk onto the chain link and set to desired grinding depth.
Tighten the setting wheel (3).
Once you have adjusted the machine to your required settings, the machine may be switched on and
grinding may start by a careful thrust on the grinding disk. Adjust the pressure as necessary.
4.7- Grinding depth delimiter
Find out in below Table1 which is the size of the depth delimiter back grinding.
Grinding the depth delimiter, the screw clamp position shall always be 0°.
Once your chain has been fully sharpened, you must make sure that the depth limiter spacing is
maintained (see Fig.8): the depth limiter (g) must be lower than the cutting links (f). You may use a
file (not provided) to grind the depth limiter (g) to the specifications for your chain.
Fig.8
Fig.6
Fig.7
V. OPERATION
5.1- Intended use
- The product is intended for indoor domestic use.
- The product is intended for sharpening saw chains within the limits of the sharpener.
- This power tool may not be used to do other things outside of the described scope.
- Do not use the machine for unsuitable purposes (for ex. for cutting wood, metal, plastic...)
- The tool is not intended for professional or industrial use.
5.2- Operation:
1. Prepare chain for sharpening (clean it as necessary) and lay it properly on the guide plates
2. Adjust settings according to the specifications for your chain or according to your needs.
3. Connect product to a power source (refer to characteristics on product).
4. Wear appropriate protective equipment.
5. Firmly hold tool. Always maintain a balanced and secure position.
6. Press ON switch (I) to start machine.
7. Start sharpening (Refer to 4.6)
8. Place grinding disk on chain link. Do not make sudden movements.
Lower the disk on the chain link surface, do not apply excessive pressure.
9. Once work is finished, stop product by pressing OFF switch (0).
Note: do not touch tool until the grinding disk has come to a complete stop.
Page 19 of 32
Publicité
