Yamaha A-S2100 Mode D'emploi page 22

Connections
■ Connecting a component supporting
the trigger function such as a Yamaha
AV receiver
The operations of this unit can be controlled in
synchronization with the operations of the connected
component, such as a Yamaha AV receiver (power ON/
STANDBY or MAIN DIRECT input selection).
Connect the PRE OUT jacks and the TRIGGER OUT jack
of the Yamaha AV receiver to this unit as illustrated
below:
Rear panel of A-S2100
INPUT
ATTENUATOR PHASE
BYPASS ATT. NORMAL INV. + HOT
(-6dB)
R L
SPEAKERS R CH
+ A
BAL
R L R L R L
+ B
TUNER CD LINE 1
R L
GND
PHONO
A OR B:4 MIN. /SPEAKER A+B:8 MIN. /SPEAKER
MAIN IN
RCA stereo
cable
Yamaha AV receiver, etc.
with PRE OUT and
TRIGGER OUT jacks
When the power of the connected component is turned on,
this unit turns on and the input is set to MAIN DIRECT
automatically.
When MAIN DIRECT is selected as the input source, this
unit enters STANDBY mode if the power of the connected
component is turned off.
Note
To enable synchronization, turn off this unit before connecting
the component to the MAIN IN jacks. The synchronization
cannot be activated when the STANDBY/ON, OFF switch of the
unit has been set to OFF.
22
En
NORMAL (EIA) TRIGGER REMOTE SYSTEM CONNECTOR
AUTO POWER STANDBY
IN IN OUT
2 1 GND
3
ON OFF
- COLD
SPEAKERS L CH
LINE2
A +
R L R L
REC PRE OUT
AC IN
B +
PB MAIN IN
A OR B:4 MIN. /SPEAKER A+B:8 MIN. /SPEAKE R
TRIGGER
IN
Monaural mini-plug
cable
PRE OUT
TRIGGER
OUT