Fisher & Paykel AquaSmart WL4027P Instructions D'installation Et Guide D'utilisation page 48

Before you call for service
US
46
CA
Wash load is out of balance.
Ensure the machine is stationary and manually redistribute the load.
Check your machine is correctly leveled (refer to pages 10 and 11).
Your machine has a suds build-up. Too much detergent may have been used for the amount of
soil in the load.
Ensure that you are using a HE, Low Sudsing, or Front Loader type detergent.
Wait for suds to dissolve (about 20 minutes).
Restart the cycle from the start (do not add more detergent).
Check the standpipe height does not exceed 95" (2413 mm).
Check that the lid is closed.
Press START/PAUSE (refer to page 21).
If the symptom persists, call your Fisher & Paykel Authorized Service Agent.
Your machine is overloaded and cannot continue the cycle.
Ensure the machine is stationary and remove items until the remaining ones can move freely.
Check that the machine is not siphoning (refer to page 9).
(no drain – there is still water in my basket)
Your machine has not successfully pumped the water out of the basket and cannot continue
the cycle.
Ensure the drain hose is correctly installed.
Check that the drain hose is not kinked or squashed.
Switch the washer off at the power supply for one minute. Switch back on.
Select RINSE or SPIN and touch START/PAUSE to check if the warning has cleared.
Single beep every second and...
NUMBER SHOWS ON THE DISPLAY (this is a fault code)
Turn your machine off at the wall.
1
Wait 1 minute and turn it back on.
2
Remove load and retry.
3
Perform a rinse or rinse and spin.
4
If the fault re-occurs repeat steps 1 and 2.
5
If the washer still will not work, call your Fisher & Paykel Dealer or Authorized Service Agent to
arrange service (refer to page 53).
(out of balance)
(suds lock – I have too many suds)
or (lid lock or lid open – I can't lock the lid or the lid is open)
(too full – I am overloaded)