Fisher & Paykel AquaSmart WL4027P Instructions D'installation Et Guide D'utilisation page 37

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Spin Speed
Your AquaSmart™ washer offers three spin speeds: FAST (maximum 1100 rpm),
MEDIUM (670 rpm) and SLOW (330 rpm), plus an additional NO SPIN option. The default spin
speed for each cycle can be changed. Note: not all spin speed options are available for some
cycles for clothes care reasons. Simply increase or decrease your spin speed by touching the SPIN
SPEED button. NO SPIN will end the cycle after the rinse, allowing you to remove drip-dry items
before you proceed the washer to its final spin. Once drip-dry items have been removed, touch
POWER, select SPIN (change the SPIN SPEED if necessary, eg select SLOW for delicate or creasable
items) and touch START/PAUSE.
Note: your washer will optimize the spin speed according to the level of out-of-balance in the load.
Wash Boost (selected models only)
If you have stains in your wash load you can add a number of short soaks to the wash to help
remove these by using the WASH BOOST option. Select the WASH BOOST option to ON.
Options
Quick
Use the QUICK option to save time on most cycles. Wash, rinse and spin times of the cycle will be
shortened.
Note: the QUICK option is available on selected cycles only. If QUICK is not available for a cycle,
your washer will skip over it in the OPTIONS menu.
Soak
The SOAK option provides a two hour soak during the middle of the wash phase of the cycle.
The machine will then complete the rest of the cycle. During SOAK, the washer will agitate for a few
seconds every minute. To perform a soak during a cycle, simply select SOAK from the OPTIONS menu.
To exit SOAK, touch START/PAUSE and select RINSE. Change the SPIN SPEED if necessary
(eg select SLOW if washing delicate, or creasable items) and touch START/PAUSE.
Note: if the SOAK option and QUICK option are selected on any given cycle, the soak time will be
reduced to one hour.
Important!
Ensure items are colorfast before using soak.
Bleach
If you wish to use bleach, ensure BLEACH is selected. Your washer will adjust the cycle so that the
bleach is dispensed correctly and safely. This also changes the rinse option to ensure thorough
removal of any bleach residue.
Softener
If you wish to use fabric softener, ensure SOFTENER is selected. This will adjust the rinse part of
the cycle so that softener is dispensed correctly.
Wash cycle options
US
35
CA

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Aquasmart wl4027g

Table des Matières