Installing Battery Pack Into Vacuum; Battery Pack Removal - Nobles ASPEN 6B Serie Manuel D'utilisation Et De Pièces

INSTALLING BATTERY PACK INTO
VACUUM
ATTENTION
To avoid damage to the battery contacts, always
turn power switch to the off position whenever
installing or removing battery pack from machine.
1. Ensure power switch is turned off.
2. Completely slide the battery pack into the battery
housing until it clicks into place. The connector is
spring-loaded, battery pack must be fully engaged
to insure proper installation.
The power level indicator will display the approximate
remaining runtime on the battery pack. When the
battery power level indicator button is pressed,
one to four indicators will light up, indicating the
approximate battery charge remaining as follows:
All 4 lights on: Full Charge
3 lights on: 70% Charge
2 lights on: 45% Charge
1 light on: 25% Charge
1 light on and blinking: Low battery,
replace/recharge battery pack
Nobles Aspen 6B, (01-2021)

BATTERY PACK REMOVAL

ATTENTION
To avoid damage to the battery contacts, always
turn power switch to the off position whenever
installing or removing battery pack from machine.
1. Ensure power switch is turned off.
2. Lift the battery handle to the horizontal position as
shown.
3. Pull the battery release knob upward then pull the
battery handle outward to remove battery pack.
NOTE: It may be necessary to apply slight inward
pressure to battery pack to assist in knob release.
4. Store battery pack indoors in a cool, dry area.
English
EN
9