Installing Vacuum Hose/Wand; Machine Setup - Nobles VIPER Manuel Opérateur

4. Secure power cord with factory-installed cord
clamp, located on handle (Figure 2).
FIG. 2
5. Wrap power cord around quick release hook and
the lower handle hook.

INSTALLING VACUUM HOSE/WAND

1. Slide hose cuff over spout on bag compartment lid
and wand into base cuff as shown. Snap wand
into retainer clip (Figure 3).
2. Store crevice tool on carrying handle (Figure 3).
Spout
FIG. 3

MACHINE SETUP

WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
1. Install filter bag (pre--installed). Depress latch on lid
to open bag compartment (Figure 4).
Contact distributor for optional cloth bag #900034.
Viper Upright Vacuum Cleaner (06- -03)
Wand
Base
Cuff
Home Find... Go To..
NOTE: The machine will not operate without a filter
bag in place. The protective vacuum motor lockout
device will automatically sense when a bag is not
installed.
FIG. 4
2. Adjust brush height. Turn brush height adjustment
dial to desired setting as follows (Figure 5):
Brush Height Settings:
1--2 Short Carpet Pile
3--4 Medium Carpet Pile
5--6 High Carpet Pile
FIG. 5
OPERATION
7