Machine Setup; Vacuum Bags; Filters - Nobles ASPEN 6 Manuel D'utilisation Et Carnet De Pièces Détachées

EN English

MACHINE SETUP

VACUUM BAGS

Each new machine is equipped with two paper bags
and a cloth filter bag.
For optimum filtration and dust containment, always
use paper bag with cloth filter bag.
To Install Vacuum Bag:
1. Turn off power switch and unplug machine from
wall outlet.
2. Remove vacuum hose from lid, release the two lid
latches and remove lid.
3. To install paper bag, simply insert the paper bag
inside the cloth filter bag, aligning cardboard collar
with cloth bag seal.
Cloth
Filter
Bag
4. Replace lid and lock latches. Insert vacuum hose
into lid.
6

FILTERS

The machine is equipped with a pre- installed HEPA
filter and exhaust filter. The HEPA filter (High Efficiency
Particulate Air) captures fine dust particles at a total
filtration of 99.97% @ 0.3 microns. The exhaust filter
captures the carbon brush dust created from the motor.
Before operating machine, make sure filters are
installed.
For optimum machine performance, it is important to
replace the filters every six months.
To Replace HEPA Filter:
1. Turn off power switch and unplug machine from
wall outlet.
2. Remove bag compartment lid from machine.
3. Remove cloth bag to access HEPA filter.
4. Pull off the grid plate located over HEPA filter and
depress the two retainer clips to remove filter.
5. Insert new HEPA filter and replace grid plate, cloth
bag, paper bag and lid.
Paper
Bag
To Replace Exhaust Filter:
1. Turn off power switch and unplug machine from
wall outlet.
2. Pull off the filter holder from bottom of machine to
access exhaust filter.
3. Install new filter and snap filter holder back into
position.
Nobles Aspen 6, Aspen 10 (01- 2015)