Machine Components; Machine Setup - Nobles MAGNA TWIN 1600 Manuel Opérateur Et Piéces

OPERATION

MACHINE COMPONENTS

1
9
2
5
3
6
4
13
7
1. Handle
2. Attachment Tool Elbow
3. Vacuum Hose
4. Brush Housing
5. Vacuum Bag Housing
6. Brush Height Adjustment Knob
7. Brush
8. ON/OFF Switch
9. 15m (50 ft) Power Cord
10. Door Latch/Upper Cord Hook
11. Rear Door
12. Lower Cord Hook
13. Handle Release Foot Latch
14. Exhaust Vent
15. Rear Wheels
16. Serial Number Tag
17. Brush Circuit Breaker (bottom side)
12
8
10
11
12
14
16
17
15
Home Find... Go To..

MACHINE SETUP

1. Carefully check carton for signs of damage.
Report damages at once to carrier.
NOTE: If rear door has become misaligned during
shipment, loosen nuts at hinge, realign door and
re- -tighten nuts.
2. Vacuum is shipped fully assembled. A paper
vacuum bag is factory installed and is ready for
operation.
Attachment Tool Kit is sold separately. If cleaning
with attachments see Attachment Tool Operation.
3. Plug power cord into grounded wall outlet
(Figure 1).
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 1
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
Magna Twin 1600/2200/2600 (10- -04)
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)