Bosch BO-51843 Instructions De Service Originales page 9

4
5
6
Removal process
Always attach the removal device so that the pulleys are
pointing to the respective corners .
Use the vacuum pump (pumping approx . 20–25 times)
until the red ring is no longer visible . To detach the removal
device, lift the edge of the rubber suction cup slightly while
firmly keeping hold of the device .
Seen from the inside, the removal process takes place in
an anti-clockwise direction; starting in the bottom right
hand corner, about 6–10 cm from the bottom edge of the
windscreen . (Fig . 3)
Use the cordless screw driver slowly to the right, adjusting
the speed depending on load . During this process hold the
removal protector internally between the windscreen removal
cord and the dashboard, shaft or roof lining, so that the
interior of the vehicle cannot be damaged . Now continue with
the removal process until the windscreen removal cord has
reached the bottom right corner .
Release the removal device and now attach it to the top right
corner (Fig . 4) .
Continue the removal process as described above in a clock-
wise direction, while using the removal protector throughout
the entire removal process .
Upon reaching the top right corner, change the position
again to the top left corner (Fig . 5) . Then change position
to the bottom left corner (Fig . 6) and complete the removal
process .
Now remove the removal device from the screen and release
the fastening hooks from the vehicle body .
You can now lift out the screen .
rpm
≦ 25°
English | 9