Publicité
5-19
8) Install the fuel tank bracket by installing
the bolts 2.
9) Install 2 bolts 1 into the rear section of
the fuel tank.
10) Prepare the engine for starting. See
"STARTING ENGINE" for procedures.
Be sure the engine is in Neutral and that
the lanyard lock plate is attached to the
engine stop lanyard switch.
11) Turn the lever 5 on the carburetor to
operate the choke system when the
engine is cold. After the engine starts,
return the lever to the original position.
12) While lifting the fuel tank, insert the
knotted end of the emergency starter
rope into the notch in the flywheel rotor
and wind the rope 1 to 2 turns clock-
wise.
NOTE:
@
If the rope is too long after winding it around
the flywheel, shorten its length at the han-
dle.
@
13) Pull the rope slowly until resistance is
felt.
14) Give a strong pull straight out to crank
and start the engine. Repeat if neces-
sary.
15) Install the top cowling.
GB
Publicité
Chapitres
