Cd Player (Cd-1330) - Yamaha MCS-1330 Mode D'emploi

Masquer les pouces Voir aussi pour MCS-1330:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 32

CD player (CD-1330)

Problem
Power does not turn
The plug is not completely inserted.
on
The receiver and the CD player are
connected incorrectly.
The receiver is set incorrectly.
No sound or
The sampling rate of a MP3 or WMA file
distorted sound
may not be compatible with the CD
player.
Disc playback does
You may use a CD-R/RW that is not
not start.
finalized.
The disc label may not be facing up.
The disc may be defective.
MP3/WMA disc may not contain
sufficient music tracks to be played back.
The sampling rate of a MP3 or WMA file
may not be compatible with the CD
player.
The USB device
Check that the USB device is connected
cannot be
correctly.
recognized.
Not linked with the
The system control cable is disconnected
receiver
from the system connector jack of the
receiver and/or the CD player.
■ USB
Note
In case of a transmission error without a status message appearing in the front panel of this unit, check the connection to the USB device
(see page 11).
Status message
NO USB
The USB device is not connected.
OVER CURENT
Connected the USB device not playable
on this system.
Connected the USB device diagonally.
Cause
Connect the power cable firmly.
Check the connection with the receiver.
Check the setting (INPUT/Volume/MUTE/
Headphone) of the receiver.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Finalize the CD-R/RW.
Check that the disc label is facing up.
Try to play back another disc. If the same problem
does not happen, the disc you want to play back is
defective.
Check that your MP3/WMA disc contains at least 5
MP3/WMA music files.
Check the sampling rate and bit rate of an MP3 or
WMA file are compatible with the CD player.
Connect the USB device firmly.
Connect the receiver and the CD player with the
system control cable firmly.
Cause
Connect playable USB device.
Disconnect the USB device. Change input source
other than USB and select USB an input source
again. Then connect playable USB device again.
TROUBLESHOOTING
Remedy
Remedy
See
page
9
9
24
24
11
9
See
page
11
23
En

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

R-1330Cd-1330Ns-bp400

Table des Matières