Connecting External Components; Connecting A Cd Or Md Recorder - Yamaha PianoCraft CRX-E320 Mode D'emploi

CONNECTING EXTERNAL COMPONENTS

You can connect external components such as a CD or MD recorder to this unit. For information on your component,
refer to the owner's manual supplied with the component.

Connecting a CD or MD recorder

If you connect your CD or MD recorder to this unit using
an optical cable, you can digitally record the audio source
played on this unit. You can also select the connected CD
or MD recorder as an input source for this unit (see
page 32).
CAUTION
Do not connect the power cables of this unit and your external
component until all cable connections are completed.
Note
Radio stations are not output from the DIGITAL OPTICAL OUT
jack. To record FM/AM broadcasts, use a commercially available
audio cable to connect the AUX OUT L/R jack on this unit to the
analog input jack on your recorder.
DIGITAL
OPTICAL
IN
Optical
cable
DIGITAL
OPTICAL
SUB WOOFER
OUT
OUT
12
En
Connecting external components
CD or MD
recorder
ANALOG
OUT IN
L
R
Audio
cables
MAINS
AUX
FM
75
IN OUT
L
R
•
Connect the DIGITAL OPTICAL OUT jack on
this unit to the digital input jack on your CD
or MD recorder using an optical cable.
•
Connect the AUX OUT jacks on this unit to
the analog input jacks on your CD or MD
recorder using an audio cable.
•
Connect the AUX IN jacks on this unit to the
analog output jacks on your CD or MD
recorder using an audio cable.
About the AUX jacks
• The signal input from the AUX IN jack is not output
from the AUX OUT jack on this unit.
• The digital and analog signal circuits are independent
of each other. Analog input signals are output only
from the analog output jacks.
About the DIGITAL jack
• The digital jack is compatible with PCM signal.
• The digital jack is designed based on EIA standards.
To make a digital connection, use an optical cable that
meets the EIA standards.