Connection; Connecting Speakers/Antenna/Subwoofer - Yamaha CRX-332 Mode D'emploi

Connecting speakers/antenna/subwoofer

Follow the procedure below to connect the speakers and FM antenna to this unit. For information on your speakers, refer
to the owner's manual supplied for the speakers.
If a subwoofer is connected, low-frequency audio signals are output through SUBWOOFER OUT.
CAUTION
Do not connect the power cable of this unit until all cable connections are completed.
Subwoofer (sold
separately)
Notes
• If you connect a subwoofer, use a subwoofer that has a built-in amplifier.
• Be sure to connect the left channel (L), right channel (R), "+"(red) "–"(black) properly. If the connections are faulty, no sound will be
heard from the speakers, and if the polarity of the speaker connections is incorrect, the sound will be unnatural and lacks bass.
• Do not let the bare speaker wires touch each other or do not let them touch any metal part of this unit. This could damage this unit and/
or the speakers.
• Use speakers having more than 6 Ω impedance.
• There is a chance that placing speakers too close to a CRT-based (Braun tube) TV set might impair picture color. Should this happen,
move the speakers away from the TV set.
4
En

CONNECTION

Subwoofer cable
(sold separately)
FM antenna
Notes
• The antenna should be stretched out.
• If you use an outdoor antenna instead of the supplied FM
antenna, reception will be better.
• If radio reception is poor, change the height, direction, or
placement of the antenna.
• If you use an FM antenna that is not supplied with the unit,
make sure that the base of the antenna is not threaded.
Be sure to remove insulation
from the end of each speaker
cable.