Remote Control; Disc Playback - Yamaha PianoCraft CRX-E320 Mode D'emploi

Troubleshooting

Remote control

Problem
The remote control does not
work properly.

Disc playback

Problem
Some button operations do
not work.
Playback does not start
immediately after pressing h.
The disc is ejected.
The message "No Disc"
appears in this unit display
even though a disc is
inserted.
36
En
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this
unit may be exposed to direct
sunlight or lighting (inverted
fluorescent lamps).
The batteries may be worn out.
Cause
The disc loaded into this unit may not
be compatible.
The disc may not be set in the disc
tray properly.
The disc may be dirty.
The disc loaded into this unit may not
be compatible.
When this unit was moved from a
cold to warm place, condensation
may have formed on the disc reading
lens.
The disc loaded into this unit may not
be compatible.
The disc may not be set in the disc
tray properly.
Solution
For information on the remote control
operation range, refer to "Using the
remote control" (see page 8).
Change the lighting or orientation of
this unit.
Replace the batteries with new ones
(see page 8).
Solution
Use a disc supported by this unit (see
page 38).
Set the disc in the disc tray properly.
Wipe the disc clean.
Use a disc supported by this unit (see
page 38).
Wait for an hour or two, and try again.
Use a disc supported by this unit (see
page 38).
Set the disc in the disc tray properly.