Configuring The System Settings (Advanced Setup Menu); Advanced Setup Menu Items; Changing The Speaker Impedance Setting (Sp Imp.); Selecting The Remote Control Id (Remote Id) - Yamaha R-N500 Mode D'emploi

Configuring the system settings (ADVANCED SETUP menu)

Configure the system settings of the unit while viewing the front display.
1
Turn off the unit.
2
While holding down RETURN on the front
panel, press A (power).
A
(power)
3
Rotate SELECT/ENTER to select an item.
4
Press SELECT/ENTER to select a setting.
5
Press A (power) to set the unit to turn off and
turn it on again.
The new settings take effect.

ADVANCED SETUP menu items

Item
Changes the speaker impedance
SP IMP.
setting.
Selects the unit's remote control ID.
REMOTE ID
Restores the default settings.
INIT
Updates the firmware.
UPDATE
Checks the version of firmware
VERSION
currently installed on the unit.
RETURN
SELECT/ENTER
Function Page
37
37
38
38
38
Configuring the system settings (ADVANCED SETUP menu)
Changing the speaker impedance
setting (SP IMP.)
SP IMP.
Change the unit's speaker impedance settings depending
on the impedance of the speakers connected.
Settings
Select this option when you connect 4-ohm
4 
speakers to the unit.
8 
Select this option when you connect 8-ohm or
higher speakers to the unit.
(default)
Selecting the remote control ID
(REMOTE ID)
REMOTE ID
Change the unit's remote control ID so that it matches the
remote control's ID (default: ID2). When using multiple
Yamaha AV receivers, you can set each remote control
with a unique remote control ID for its corresponding
receiver.
Settings
ID1, ID2 (default)
■ Changing the remote control ID of the
remote control
1
To select ID1, while holding down the ID, hold
down numeric key "1" for more than 3
seconds.
To select ID2, while holding down the ID, hold
down numeric key "2" for more than 3
seconds.
Once the remote control code is successfully
registered, "Rem: Success" appears on the front
display.
If "Rem: Fail" appears on the front display,
registration has failed. Repeat from Step 1.
y
The registered remote control codes (p.39) are not cleared even if
you change the remote control ID.
8 MIN
ID2
37
En