Yamaha R-N500 Mode D'emploi page 51

■ Remote control
Problem
Wrong distance or angle.
The remote control
does not work nor
function properly.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
The batteries are weak.
The remote control ID and this unit's ID
do not match.
The remote control code was not correctly
set.
Even if the remote control code is
correctly set, there are some models that
do not respond to the remote control.
You did not press the input selection key
corresponding to the component you are
trying to control.
Cause
The remote control will function within a maximum
range of 6 m (20 ft) and no more than 30 degrees off-
axis from the front panel.
Reposition this unit.
Replace all batteries.
Switch the remote control ID or this unit's ID.
Try setting another code of the same manufacturer
using "LIST OF REMOTE CONTROL CODES" at
the end of this manual.
Use the supplied remote control for the components.
Press the input selection key corresponding to the
component you are trying to control, and then press
the desired remote control key(s).
Troubleshooting
Remedy
See
page
9
—
—
37
—
—
—
47
En