Remote Control - Yamaha MCS-1330 Mode D'emploi

TROUBLESHOOTING
■ FM
Problem
FM stereo reception is noisy.
There is distortion, and clear
reception cannot be obtained
even with a good FM antenna.
The desired station cannot be
tuned into with the automatic
tuning method.
■ iPod
Note
In case of a transmission error without a status message appearing in the front panel of the receiver, check the connection to your iPod
(see page 11).
Status message
CONNECT ERR
UNKNOWN TYP
CONNECTED
NOT CONNECT
CAN'T PLAY

Remote control

Problem
The remote control
does not work nor
function properly.
22
En
Cause
The characteristics of FM stereo
broadcasts may cause this problem
when the transmitter is too far away or
the antenna input is poor.
There is multi-path interference.
The signal is too weak.
Cause
There is a problem with the signal path
from your iPod to the receiver.
The iPod being used is not supported by
the receiver.
Your iPod is properly stationed in a
terminal, and the connection between
your iPod and the receiver is complete.
Your iPod was removed from an iPod
terminal of the receiver.
The receiver cannot play back the songs
currently stored on your iPod.
Cause
The remote control may be operated
outside its operation range.
The remote control sensor on this system
may be exposed to direct sunlight or
lightening (invented fluorescent lamps).
The battery may be worn out.
There are obstacles between the sensor of
this system and the remote control.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Adjust the antenna position to eliminate
multi-path interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Remedy
Turn off the receiver and try resetting your iPod.
Only iPod (Click and Wheel), iPod nano, iPod mini,
and iPod touch are supported.
Station your iPod back to the terminal of the
receiver.
Check that the songs currently stored on your iPod
are playable.
Store some other playable music files on your iPod.
Remedy
For information on the remote control operation
range, refer to "Using the remote control".
Change the lighting or orientation of this system.
Replace the battery with new one.
Remove the obstacles.
See
page
10
—
—
—
17
See
page
11
—
11
—
—
See
page
8
8
8
8