System Operations; Basic System Operations - Yamaha MCS-1330 Mode D'emploi

SYSTEM OPERATIONS

Follow the procedure below to select an input source and adjust the sound settings on the system.
ON/STANDBY, OFF
ON/STANDBY PHONES
OFF
ON/STANDBY USB
OFF
(standby/on)
iPod
Input selection
FM
keys
VOLUME +/–
DISPLAY DIMMER
PURE DIRECT
PURE DIRECT

Basic system operations

1
Press ON/STANDBY, OFF on the front panel
of the receiver and the CD player.
2
Press (standby/on) to turn on the
receiver.
Depending on the input mode of the receiver, the CD
player also turns on by the system control connection
(see page 9). The front panel display lights up.
12
En
SYSTEM OPERATIONS
PURE DIRECT
INPUT PURE TUNER PRESET
DIRECT
MIN
INPUT VOLUME
CD USB
PHONO AUX
PRESET
TUNING
VOL
VOL
TONE BALANCE
TONE/BALANCE
/
SLEEP
MUTE
MUTE
3
Press one of the input selection keys (or
rotate INPUT on the front panel) to select the
desired input source.
VOLUME
4
Start playback on the selected source
MAX
component or select a radio station.
For information on the disc/USB device playback,
see page 14, and for information on tuning, see
page 17.
5
Press VOLUME +/– (or rotate VOLUME on the
front panel) to adjust the volume to the
desired output level.
■ To adjust the audio quality
1
Press TONE/BALANCE to select BASS,
TREBLE, or BALANCE.
2
To adjust the setting, press
BASS:
TREBLE:
BALANCE: Adjusts the volume level of each left
■ Pure Direct mode
The Pure Direct mode shuts down the tone control
circuitry and front panel display, allowing you to enjoy
pure high-fidelity sounds.
Press PURE DIRECT (or PURE DIRECT on the
front panel) to turn on the Pure Direct mode.
The PURE DIRECT indicator lights up, and the front
panel display goes off.
Notes
• If you carry out operations while the Pure Direct mode is turned
on, the front panel display lights up briefly to acknowledge the
command.
• While the Pure Direct mode is turned on, neither BASS,
TREBLE, nor BALANCE is available.
To turn off the Pure Direct mode
Press PURE DIRECT again so that PURE DIRECT
indicator turns off and the front panel display lights up.
■ Muting the sound (MUTE)
Press MUTE to turn off the sound.
MUTE ON appears on the front panel display.
To restore the sound, press MUTE again or press
VOLUME +/–.
or
Adjusts the low frequency response.
Adjusts the high frequency response.
and right speaker channel.
.