Yamaha RX-V1500 Mode D'emploi page 80

REMOTE CONTROL FEATURES
4
Press and hold CLEAR using a ballpoint pen
or similar object, then press the button you
want to clear for about 3 seconds.
"C:OK" appears in the display window if clearing
was successful.
FREQ/RDS EON MODE PTY SEEK START
REC
DISC SKIP
OFF ON MACRO LEARN CLEAR RE–NAME
y
• If you continuously want to clear another function, repeat
step 4.
• Once you clear a learned function, the button reverts to the
factory setting (or to the manufacturer setting if you have
set remote control codes).
5
Press CLEAR to exit the clearing mode.
The remote control returns to the learning mode.
6
Press LEARN again to exit.
Notes
• "C:NG" appears in the display window if clearing was
unsuccessful. In this case, start over from step 4.
• "ERROR" appears in the display window if you press a button
not indicated in the respective step, or if you press more than
one button simultaneously.
78
Clearing a macro function
You can clear the function programmed for a certain
macro button.
1
Set AMP/SOURCE/TV to AMP or SOURCE.
AMP
SOURCE
TV
2
Press MACRO using a ballpoint pen or
similar object.
"MCR ?" appears in the display window.
MACRO
Note
If you do not complete each of the following steps within 30
seconds, the macro programming mode will be
automatically canceled. In this case, press MACRO again.
3
Press and hold CLEAR using a ballpoint pen
or similar object, then press the macro
button you want to clear for about 3 seconds.
"C:OK" appears in the display window if clearing
was successful.
DTV VCR 1 DVR/VCR2 DVD
REC
DISC SKIP
OFF ON MACRO LEARN CLEAR RE–NAME
y
• If you continuously want to clear another function, repeat
step 3.
• Once you clear a programmed function, the button reverts
to the factory setting (or to the manufacturer setting if you
have set remote control codes).
4
Press CLEAR to exit the clearing mode.
The remote control returns to the macro
programming mode.
5
Press MACRO again to exit.
Notes
• "C:NG" appears in the display window if clearing was
unsuccessful. In this case, start over from step 3.
• "ERROR" appears in the display window if you press a button
not indicated in the respective step, or if you press more than
one button simultaneously.