Disposal Of The Machine And Its Parts; Spare Parts- General Warnings - Orved VM Serie Mode D'emploi Et D'entretien

VACUUM CHAMBER
PACKAGING MACHINES
PROBLEM
The machine does not seal
Poor sealing
Gas quantity in bags
insufficient
Lid opens during GAS
cycle.
Vacuum not created in
containers
8.

DISPOSAL OF THE MACHINE AND ITS PARTS

For scrapping the VACUUM PACKAGING MACHINE or its parts, do not dump these in city waste bins: scrapped appliances
are not useless wastes!
The machine does not contain components that are hazardous for humans or the environment; it is made of materials that can be recycled completely
or disposed off normally.
For scrapping operations, contact specialist, authorized Companies. Before starting dismantling operations, make sure
there is enough clearance around the machine to carry out the operations easily.
In any case, make sure, every part of the machine is disposed off in accordance with the legislation applicable in the country of use.
8.1 DISPOSING PNEUMATIC SPRINGS
DANGER! Danger of serious injury: the pneumatic springs are loaded at about 180 bar, therefore they must not be cut or
damaged as they can burst throwing off splinters.
The disposal of these parts must be done exclusively by qualified personnel.
9. SPARE PARTS: GENERAL WARNINGS
For ordering spare parts, always indicate the following data:
• MACHINE SERIAL NUMBER (see CE plate on the back of the machine)
• SPARE PART CODE (see Table)
10. THE MANUFACTURER
Thank you for your trust.
The manufacturer reserves the right to make technical and/or aesthetic modifications to our products at any moment, without any prior notice.
REV. 00 - Cod.: 1500154
POSSIBLE CAUSES
Sealing bar connection
wires disconnected
Sealing Bar wire broken.
For appliance with gas
option: gas quantity more
than 70%.
Sealing bar fuse blown.
Seal bag perforated.
Sealing bar dirty.
Sealing time insufficient
for bag basic weight.
Teflon cover worn.
Red silicone worn.
Gas flushing time
insufficient.
Gas cylinder pressure
insufficient.
Gas nozzle not inserted in
bag mouth.
Cylinder valve or pressure
reducer closed.
Gas percentage too high.
Cover not placed correctly.
ELECTRO-MECHANICAL VERSION
Check connections or clean the contacts
Change wire.
(Contact a Service Centre)
Reduce gas percentage using
"GAS" control knob.
Change PF2 fuse on power board.
Change seal bag.
Clean sealing bar.
Increase sealing time using
"SEAL" control knob.
Change Teflon cover.
Change red silicone.
Increase gas percentage using
"GAS" control knob.
Adjust pressure on cylinder reducer to 1 bar.
Reposition bag by inserting gas nozzle in the bag mouth.
Open cylinder valves and adjust pressure reducer to 1.0 bar.
Reduce gas percentage using
"GAS" control knob.
Reposition then create vacuum by pressing slightly on the lid.
69
Operation and maintenance manual / Ed. 10 - 2005
MAINTENANCE
SOLUTION
DIGITAL VERSION
Reduce gas percentage using
"GAS" key.
Increase sealing time using
"SEAL" key.
Increase gas percentage using
"GAS" key.
Reduce gas percentage using
"GAS" key.
GB
G B
GB