LERICA LEVAC C30 M8 Mode D'emploi Et D'entretien page 48

MAINTENANCE
GB
7.3.1 CLEANING THE PLEXIGLAS COVER
• Wipe using a cloth soaked in potable water or a detergent specially meant for Plexiglas (maximum temperature 40°C).
• Do not use other types of detergents.
• Dry the cover thoroughly.
7.3.2 CLEANING THE SEALING BARS
ATTENTION!
Do not start cleaning operations with the sealing bars hot, as there is danger of burns.
• Clean the upper part of the sealing bar using a clean cloth soaked in potable water.
7.3.3 CLEANING THE VACUUM CHAMBER
1) Switch the machine off by means of the ON/OFF main switch and disconnect the plug from the mains socket.
2) Lift the sealing bar by rotating it upwards (A - Fig.1)
3) Hold the sealbag and pull it upwards (B - Fig. 2).
4) Insert the safety cap (C) in the central opening as shown in (Fig. 3).
5) Using a cloth soaked in a detergent and/or disinfectant solution, clean the bottom and sides of the vacuum chamber (Fig. 4); after cleaning, refit
the parts by repeating the above operations in reverse order.
7.3.4 DISINFECTING THE MACHINE
• Switch the machine off by means of the ON/OFF main switch and disconnect the plug from the mains socket.
• Spray the machine's stainless steel surface with an alcohol-based disinfectant. Do not spray on the electrical parts or in the machine's air vents.
• Leave the disinfectant to act for a few minutes.
• Wipe with a cloth soaked in potable water, then dry thoroughly with a clean cloth.
A
GB
Operation and maintenance manual / Ed. 10 - 2005
Fig. 1
C
Fig. 3
Fig. 2
Fig. 4
48
V ACUUM CHAMBER
PACKAGING MACHINES
B
REV. 00 - Cod.: 1500228