Using The Appliance; Preparation - LERICA LEVAC C30 M8 Mode D'emploi Et D'entretien

USING THE APPLIANCE

GB
6. USING THE MACHINE
6.1

PREPARATION

WARNING! The product to be packed must be dry and cold to obtain maximum vacuum. The pump performance is reduced
if there is moisture in the product or the vacuum chamber. Therefore, clean the vacuum chamber and insertion plates
carefully. Soft products may be damaged by the compression in the bag when the cycle is complete. Use bags having
thickness and size suitable for the product hardness and dimensions.
1) Lower lid holder (A): the vacuum chamber plexiglas cover (B) opens.
Position the maximum number of insertion plates (C) the chamber can hold, depending on the dimensions of the product to be packed.The longest
insertion plate (in models with insertion plates of different lengths) must always be at the top as it will otherwise hinder vertical movement of the
sealing bar.
2) Choose a bag suitable for the product to be packed (the product must take up 2/3 of the bag volume). Insert inside the vacuum chamber the bag
(D),containing the product to be packed and center it on the sealing bar (E), so that the open edge projects by about 20mm beyond the bar. For
models with bar length sufficient to pack a number of bags simultaneously and for multi-bar models, distribute the bags at regular distances (=)
(Fig. 1).
E
GB
Operation and maintenance manual / Ed. 10 - 2005
D
•
•
•
Fig. 1
C
42
V ACUUM CHAMBER
PACKAGING MACHINES
B
•
•
A
REV. 00 - Cod.: 1500228