LERICA LEVAC C30 M8 Mode D'emploi Et D'entretien page 45

VACUUM CHAMBER
PACKAGING MACHINES
CREATING VACUUM IN EXTERNAL CHANNELLED BAGS (See page 40)
1) Switch the machine on and set the sealing value by selecting the SEAL function using
functions if present (it is advisable to program a special cycle).
2) Press the yellow button
3) When vacuum formation inside the bag is complete, i.e. the vacuum gauge indicates -1.0bar, press
Bag sealing follows and the cycle is completed with re-entry of air and opening of the lid.
WARNING!
THIS OPERATION IS ONLY POSSIBLE WITH CHANNELLED BAGS.
CHANNELLED
BAG
•
•
When the appliance has completed the maximum limit of 15,000 cycles, the display shows - immediately when the
machine is switched on and at the end of every work cycle - "AL oil", which indicates the need to change the pump
oil. Proceed with the operation as described in the "CHANGING PUMP OIL" paragraph.
The number of cycles performed can be displayed by pressing the
display shows "cic" and the number expressed in hundredths.
For example, "cic 048" indicates that 48×100 = 4800 work cycles have been reached
To reset the value, after pressing the four buttons mentioned above, immediately press
REV. 00 - Cod.: 1500228
; position the bag at about 20 mm beyond the sealing bar (G), then start up the cycle by lowering lid (H).
•
G
OIL CHANGE ALARM AND WORK CYCLES DISPLAY MODELS
USING THE APPLIANCE
at 2.7 - 3 seconds; deactivate the GAS and SOFTAIR
,
45
.
H
•
and keys simultaneously; the
.
Operation and maintenance manual / Ed. 10 - 2005
GB
GB