LERICA LEVAC C30 M8 Mode D'emploi Et D'entretien page 33

VACUUM CHAMBER
PACKAGING MACHINES
2.4.2.6 MODIFYING THE APPLIANCE
DANGER!
-Do not make any modifications or changes on the machine without the manufacturer's permission.
- Replace all deteriorated, worn or damaged parts immediately (replacement must be done by a qualified technician).
- Use only genuine spare parts.
2.4.2.7 FIRE PREVENTION
DANGER!
-Keep the air vents clear (distance from surrounding parts at least 10 cm).
- Do not place the machine near inflammable products.
DANGER! Danger of burns: if alcohol-based or inflammable products are used for disinfecting, air the area. Do not use
naked flames near the machine! Do not smoke!
2.4.2.8 CLEANING AND DISMANTLING THE MACHINE
ATTENTION!
-Clean the machine regularly by following the instructions given in this Manual.
Use and handle cleaning products according to the manufacturer's instructions.
-Scrapping and disposal of the machine, parts and products used for cleaning the machine must be done strictly
in compliance with the applicable standards.
2.4.2.9 HAZARDS DERIVING FROM PNEUMATIC SPRINGS APPLIED ON THE PLEXIGLAS COVER
DANGER!
-Never open the pneumatic springs, as the pressure inside them is extremely high(about 180 bar).
-Before scrapping the machine, discharge the pneumatic springs. Request instructions for disposal.
2.4.2.10 HAZARDS DERIVING FROM USE OF GAS IN MACHINES WITH GAS OPTION
DANGER!
-Use only nitrogen N
-Detonation hazard! Do not use oxygen O
-Observe the gas producer's instructions strictly for correct use of gas cylinders and gas pressure reducers!
REV. 00 - Cod.: 1500228
or carbondioxide CO or nitrogen+carbondioxide mixture N
2 2
or other explosive or inflammable gases.
2
GENERAL INFORMATION
-CO
2
33
.
2
Operation and maintenance manual / Ed. 10 - 2005
GB
GB