Absorption / Transmission Mode; General Points; Measurement; Results Printing - Secomam UviLine Serie Manuel D'utilisation

UviLine Series

9 ABSORPTION / TRANSMISSION MODE

1.28

GENERAL POINTS

The absorbance or transmittance respectively is measured without the use of any methods. All settings are configured
during measurement.
The absorbance or transmittance can alternatively be measured against the air or against a reference solution determined
by the operator. The settings of the last measurement are active.
1.29

MEASUREMENT

- Press F2 key [Wavelength] to enter a new wavelength.
- Press <ZERO BLANK> key to start the zero measurement.
- Press <START ENTER> key to start the sample measurement (Absorbance and transmittance are displayed).
- Press <START ENTER> key to start a new measurement.
When there were several measurements, the four last are displayed at the same time as measurement in progress
- Press F4 key [Continuous] to measure the same sample several time again.
- Press F4 key [Stop] to stop the continuous measurement.
1.30

RESULTS PRINTING

- Press <PRINT> key to print the results.
UviLine 9300 7449001 1.14
Administrator
Time of measurement:
Wavelength:
Measured value:
07/01/2015 14:05:46
525 nm
0.278 52.8 %
- 49 -