Roland SonicCell SRX Serie Mode D'emploi page 250

Implémentation MIDI
●Reset All Controllers (Controller number 121)
Status 2nd byte
BnH 79H
n = MIDI channel number: 0H - FH (ch.1 - 16)
* When this message is received, the following controllers will be
set to their reset values.
Controller
Pitch Bend Change
Polyphonic Key Pressure
Channel Pressure
Modulation
Breath Type
Expression
Hold 1
Sostenuto
Soft
Hold 2
RPN
NRPN
●All Notes Off (Controller number 123)
Status 2nd byte
BnH 7BH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* When All Notes Off is received, all notes on the corresponding
channel will be turned off. However, if Hold 1 or Sostenuto is ON,
the sound will be continued until these are turned off.
●OMNI OFF (Controller number 124)
Status 2nd byte
BnH 7CH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* The same processing will be carried out as when All Notes Off is
received.
●OMNI ON (Controller number 125)
Status 2nd byte
BnH 7DH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* The same processing will be carried out as when All Notes Off is
received. OMNI ON will not be turned on.
250
3rd byte
00H
Reset value
+/-0 (center)
0 (off)
0 (off)
0 (off)
0 (min)
127 (max) However the controller
will be at minimum.
0 (off)
0 (off)
0 (off)
0 (off)
unset; previously set data will not change
unset; previously set data will not change
3rd byte
00H
3rd byte
00H
3rd byte
00H
●MONO (Controller number 126)
Status 2nd byte
BnH 7EH
n = MIDI channel number:
mm = mono number:
* The same processing will be carried out as when All Notes Off is
received.
* In Performance mode, the Part Mono/Poly parameter (Part Edit)
will change.
●POLY (Controller number 127)
Status 2nd byte
BnH 7FH
n = MIDI channel number: 0H - FH (ch.1 - 16)
* The same processing will be carried out as when All Notes Off is
received.
* In Performance mode, the Part Mono/Poly parameter (Part Edit)
will change.
■System Realtime Message
●Timing Clock
Status
F8H
* This is received when Sync Mode parameter (System) is SLAVE.
●Active Sensing
Status
FEH
* When Active Sensing is received, the unit will begin monitoring
the intervals of all further messages. While monitoring, if the
interval between messages exceeds 420 ms, the same processing
will be carried out as when All Sounds Off, All Notes Off and
Reset All Controllers are received, and message interval
monitoring will be halted.
3rd byte
mmH
0H - FH (ch.1 - 16)
00H - 10H (0 - 16)
3rd byte
00H