Connecting The Power Supply - Sonoro sonoroHIFI SO-510 Mode D'emploi

4.3

Connecting the power supply

L WARNING!
Risk of injury in case of damage, or due to impr‐
oper treatment of the power cable!
If the power cable is damaged or treated improp-
erly, there is a risk of electric shock.
– Unplug the power plug from the AC outlet by
pulling it out horizontally.
– Never use the power cable if it is damaged.
L NOTICE!
Material damage due to incorrect connection
voltage!
Connection values that exceed the maximum per-
missible values for the device can irreparably
damage the device.
– Always use the included power supply.
– Ä „Technical data" on page 77
– Only operate the device if the specified elec-
trical voltage matches the voltage of your
power outlet.
Power is supplied to the device via the power cable.
1. Insert the power cable connector into the power
port on the back of the device.
i
The connector does not disappear completely
into the power port on the device.
2. Insert the power plug into the socket.
ð The power supply has been established.
82
© sonoro audio GmbH 2016