Getting Started; Unpacking Relax; Connecting The Power Supply - Sonoro Relax SO-810 Mode D'emploi

3

Getting started

3.1

Unpacking RELAX

1. Take RELAX out of the packaging and check whether RELAX or the individual
parts exhibit damages. If this is the case, do not use RELAX. Should you
detect any damage, contact your dealer or sonoro audio GmbH customer
support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of
delivery").
3. Place RELAX at a suitable location. If you want to put your RELAX on a natural
wood surface, please make sure that it is suitable. On oiled and waxed
surfaces may possibly cause stains
4. Remove the protective film from the display.
3.2

Connecting the power supply

1. Insert the top end of the adapter into the upper slot of the power supply.
2. Click the bottom end of the adapter in to lock it into place.
3. To remove, first pull back the tab on the power supply.
4. Pull the adapter upwards to remove it.
5. Insert the connector of the power adapter into the DC power input jack on
the back of RELAX.
6. Insert the power plug into a wall socket. RELAX is turned on.
© sonoro audio GmbH 2019
GB
73