Performing Initial Setup - Sonoro Relax SO-810 Mode D'emploi

3. Lift Wi-Fi antenna upwards.
4. If you want to connect RELAX to your network using an Ethernet cable,
connect an Ethernet cable from LAN port on the back of RELAX to your
router.
3.5

Performing initial setup

When RELAX is powered on for the first time, the "Language' (to be used in the
display) selection appears on the display. Then, the "Setup wizard" appears on the
display. Follow the instructions below to configure some basic settings.
1. When the "Setup Wizard" is displayed, press
rotate the navigation knob) to select "YES" and then press OK to start the
setup.
2. You are then prompted to select:
Time format (12 or 24-hour)
•
Source of auto update (Update from radio, Internet or no update).
•
Depending on the selection you have made, follow the instructions on the
display to further set up date and time, time zone, daylight saving or wireless
network. Rotate the navigation knob on RELAX or press the navigation
buttons on the remote control to make selections and then press OK to
confirm (see chapter "Using the menus").
© sonoro audio GmbH 2019
+ –
or on the remote control (or
GB
75