Inserting The Battery In The Remote Control; Using The Antennas - Sonoro Relax SO-810 Mode D'emploi

Masquer les pouces Voir aussi pour Relax SO-810:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3.3

Inserting the battery in the remote control

1.
Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2.
Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3.
Replace and close the battery compartment cover by turning the cover
clockwise using a small coin.
Do not block the infra-red sensor on the RELAX and the infra-red
transmitter on the remote control during use.
3.4

Using the antennas

1.
Screw the rod antenna located on the back of RELAX to the FM/DAB antenna
connector.
2.
If you are using the rod antenna, pull the arms of the rod antenna apart and
align the antenna so that you have the best possible reception.
For even better reception, connect RELAX to a suitable house antenna.
74
© sonoro audio GmbH 2019

Publicité

Table des Matières
loading

Table des Matières