Getting Started; Unpacking Meisterstück; Inserting The Battery In The Remote Control - Sonoro MEISTERSTÜCK SO-610 Mode D'emploi

3. Getting started

3.1 Unpacking MEISTERSTÜCK
1. Take MEISTERSTÜCK out of the packaging and check whether
MEISTERSTÜCK or the individual parts exhibit damages. If this is the case,
do not use MEISTERSTÜCK. Should you detect any damage, contact your
dealer or sonoro audio GmbH customer support immediately.
2. Check to make sure that the delivery is complete (see chapter "Scope of
delivery").
3. Place MEISTERSTÜCK at a suitable location. If you want to put your
MEISTERSTÜCK on a natural wood surface, please make sure that it is
suitable. On oiled and waxed surfaces may possibly cause stains.
4. Remove the protective film from the display.
5. Remove the protective card from the subwoofer driver.
3.2

Inserting the battery in the remote control

1. Open the battery compartment cover on the back of the remote control by
turning it anticlockwise using a small coin.
2. Insert the supplied batteries (CR2032, 3 V) with the label (+) side up.
3. Replace and close the battery compartment cover by turning the cover
clockwise using a small coin.
Do not block the infra-red sensor on the MEISTERSTÜCK and the infra-red
transmitter on the remote control during use.
© sonoro audio GmbH 2019
GB
71