Viewing Pictures From Connected Equipment - Sony BRAVIA KDS-70R2000 Mode D'emploi

Viewing pictures from
connected equipment
Switch on the connected equipment, then
perform one of the following operation.
For equipment connected to the scart sockets using a
fully-wired 21-pin scart lead (page 44)
Start playback on the connected equipment.
The picture from the connected equipment appears on
the screen.
For an auto-tuned VCR (page 8)
In analogue mode, press PROG +/-, or the number
buttons, to select the video channel.
For other connected equipment (page 43)
Press / repeatedly until the correct input
symbol (see below) appears on the screen.
On screen Labels of input jacks
display
AV1/2 or 1 or 2
AV1/2
3
AV3, AV3
or AV3
AV4 4
5 HDMI IN
AV5
AV6 6 HDMI IN
6 HDMI IN and 6 HDMI IN
AV7 or 7
AV7 C ) and
R
PC PC IN
/
/ /
(Y, P /C , P /C ) and
B B R R
(L, R)
(L, R)
or (Y, P /C , P /
B B R
(L (MONO), R)
RGB and PC IN
Additional operations
To Do this
Return to normal Press DIGITAL or ANALOG.
TV mode
Access the Input Press
signal index table index table. (Then, only in
(except for PC video analogue mode, press
input signal) select an input source, press
then press
To use the Tools menu
Press TOOLS to display the following options when
viewing pictures from connected equipment other
than a PC.
Options Description
Close Closes the Tools menu.
PAP (or Single Picture) See page 19.
Picture Mode See page 25.
Sound Mode See page 28.
Power Saving See page 31.
Sleep Timer See page 31.
i Volume* See page 32.
Auto Clock Set Allows you to switch to digital
mode and obtain the time.
* This option appears only if "i Speaker Link" is set to
"Off" (page 32).
to access the Input signal
g
.) To
F f
/ ,
.
23
GB