Sony BRAVIA KDS-70R2000 Mode D'emploi page 16

Projection lamp
Your TV uses a projection lamp as its light source. As with
any lamp, it has lifespan and needs to be replaced when the
lamp indicator flashes or the screen becomes darker.
Notes
• After switching on your TV, it may take a while (1 minute
or less) before the picture appears.
• When the projection lamp wears out, the screen goes dark.
Replace the lamp with a new Sony XL-5200 (for KDS-
55A2000, not supplied) or XL-5300 (for KDS-70R2000,
supplied) replacement lamp. How to replace the lamp, see
page 48.
Warning
The light emitted from the lamp is quite bright when your TV
is in use. To avoid eye discomfort or injury, do not look into
the light housing when the power is on.
To detach the speakers
(KDS-70R2000 only)
The speakers on the KDS-70R2000 can be detached if
required. If you use a multi-channel surround speaker
system and there is insufficient space to install the
display unit, we recommend using the speakers
detached.
1
Remove the three screws that are located
on the rear of the speaker, and pull the
speaker straight out to detach it from the
panel.
When removing the screws, use a coin to turn
them counterclockwise.
16
GB
2
Attach the side cover that came in the box.
Press the cover at the top, middle, and bottom to
make sure that it is attached securely (see
illustration).
Note
Facing the TV, make sure that the side covers marked
"R" (right) and "L"(left) are attached to the
corresponding sides of the TV.
3
Tighten the side cover with the three
screws that you removed in step 1.
When attaching the screws, use a coin to turn them
clockwise.
4
Repeat steps 1 through 3 with the speaker
on the other side.
Note
After you remove the speakers, place them in the box that
originally contained the side cover.