Technical Specifications; General Warning - Tractel blocfor ESD Manuel D'installation

B1.8A
Model
ESD
Weight (kg)* 0.98
galvanised steel
–
rope Ø 4,9 m
stainless steel
-
rope Ø 4,7 mm
PE rope - HD Ø
–
5,5 mm
webbing PES
–
width 46 mm
webbing PES
–
width 25 mm
webbing Aramid
+ PES width 1.8
16 mm
Retraction force (N) 3 à 15
Horizontal use allowed Yes
L Min (m) 1
M Max (m) 0.5
Anchorage
Device securing
point
Attaching the retractable
Operator
lanyard
* Devices fitted with M10 and M47 connectors except model B1.8B ESD
fitted with M47 and M51 connectors.

1. General warning

1. Before using your blocfor™ self-retracting fall-
arrester device, and to ensure safe, efficient use of
the harness, it is essential that the user be properly
trained in the use of the equipment and has read
and understood the information given in the manual
supplied by TRACTEL SAS. This manual should be
available at all times to all users. Additional copies
can be supplied on request.
2. Before use, it is essential that users are trained in
the use of this safety device. Check the state of
associated equipment and make sure that there is
adequate room for movement.
3. The blocfor™ self-retracting fall-arrester must only
be used by a single trained and skilled operator, or
by an operator under supervision of a user.
4. Any blocfor™ self-retracting fall-arrester device
which does not appear to be in good condition
or which has already served to stop a fall should
be inspected, with all its associated equipment,
by TRACTEL SAS or by a qualified technician
who must give written authorisation for re-use of
the system. It is recommended to make a visual
inspection prior to each use.
5. Any modification or attachment made to the
equipment cannot be done without prior written
approval from TRACTEL SAS. The equipment must
be transported and stored in its original packaging.
6. Any blocfor™ self-retracting fall-arrester which
has not been inspected over the past 12 months

Technical specifications

B1.8B B2 B5 B6
ESD ESD ESD ESD
1.30 1.02 2.17 2.22
– – – –
- - - -
– – – –
– 2 – –
– – 5 6
1.8 – – –
3 à 15 3 à 15 5 à 25 5 à 25
Yes – Yes Yes
1 – 3 3
0.5 – 1.5 1.5
Operator
Anchorage
point
B10 B10
B10 B20
Inox SR
ESD ESD
ESD ESD
4.90 4.90 4.07 8.50
10 - – 19
- 10 - -
– – 10 –
– – – –
– – – –
– – – –
5 à 25 5 à 25 5 à 25 5 à 25 5 à 25
Yes - Yes Yes
3 - 3 3
1.5 - 1.5 1.5
Anchorage point
Operator
(or in accordance with the statutory inspection
requirement of the country of use) or which has
served to stop a fall must not be used. They can
only be used again after a new periodical inspection
carried out by an approved and competent
technician who can offer written permission for use.
Failing these reviews and approvals, the blocfor™
self-retracting fall-arrester will be disassembled
and destroyed.Safety of the user is closely allied to
maintaining efficiency and resistance of equipment.
7. The maximum working load for the blocfor™ self-
retracting fall-arrester is 150 kg.
8. If the mass of the operator increased by the weight
of their equipment and tools is between 100 kg
and 150 kg, you must ensure that the total weight
(operator, equipment + tools) does not exceed the
maximum load of each of the components of the
fall-arrest system.
9. This device is suitable for use on an open air site
and for a temperature range of -35°C to +60°C.
Avoid any contact with sharp edges, rough surfaces
and chemical substances.
10. If you are responsible for assigning the equipment
to an employee or similar person, ensure that you
comply with the applicable health and safety at work
regulations.
11. The operator must be physically and mentally fit
when using this equipment. In case of doubt, check
with one's private doctor or with the works doctor. It
is forbidden for use by pregnant women.
B20 B20 B30
B30
Inox SR Inox
ESD
ESD ESD ESD ESD
8.50 7.05 15.70 15.70 13.50
- – 30 -
19 - - 30
– 18.2 – –
– – – –
– – – –
– – – –
5 à 25 5 à 25 5 à 25 5 à 25
- Yes Yes -
- 3 3 -
- 1.5 1.5 -
B30
GB
SR
–
-
30
–
–
–
Yes
3
1.5
3