Rear Panel - Teac Tascam MZ-372 Mode D'emploi

PFL switches/indicators
y
o When a PFL switch is on (PFL indicator lit), the
pre-fader signal (signal before fader adjust-
ment) can be monitored through headphones.
o When a PFL switch is off, only the normal mon-
itoring sound is output.
MIXING knob
u
Use this to mix the pre-fader and monitoring sig-
nals output to the headphones.
o Turn all the way to the PFL side to monitor
channels that have their PFL (
pressed in.
o Turn all the way to the MONITOR side to moni-
tor the monitoring signal.
PHONES VOLUME knob
i
Use this to adjust the headphone output level.
L/R SPLIT switch/indicator
o
Press to change the headphone output mode.

Rear panel

POWER switch
a
Press to turn the unit on and off.
When on, the POWER (
front of the unit.
MONITOR OUT mic mix switch
s
This sets whether or not the input signal from a mic
connected to the MAIN MIC INPUT (
front of the unit is sent to and mixed with the mon-
itoring output.
To mix the input signal from a mic connected to
the MAIN MIC INPUT (
output, set the MONITOR OUT mic mix switch to
WITH MIC.
10
TASCAM MZ-372
) switches
y
) indicator lights on the
9
) jack on the
w
) jack with the monitoring
w
o When the L/R SPLIT switch is on (indicator lit),
pre-fader signals are output from the left chan-
nel and the monitoring signal is output from
the right channel.
o When the L/R SPLIT switch is off (indicator un-
lit), the monitoring signal is output. When PFL
switches are on, the pre-fader and monitoring
signals are mixed and output together.
NO
The PFL signals are mixed with the monitoring sig-
nal, so the selected PFL signals will sound louder.
PHONES jack
p
Use this standard stereo jack to connect stereo
headphones.
Use an adapter to connect headphones with a mini
plug.
The monitoring and PFL signals can be monitored,
depending on the PFL (
switch settings.
SUB OUTPUT switch
d
Set whether the output from the SUB OUTPUT (
jacks is stereo or mono.
Set it to MONO for mono output.
MAIN OUTPUTS 1-2 (UNBALANCED) jacks
f
These analog outputs are RCA pin jacks.
Use the ATTENUATOR (
output level.
ATTENUATOR switches
g
These switch the output levels from the MAIN
OUTPUTS 1-2 (UNBALANCED) (
OUTPUTS 1-2 (BALANCED) (
Set them to OFF if the destination amplifier re-
ceives high gain, and set it to ON (-6dB) if the des-
tination amplifier receives low gain.
) and L/R SPLIT (
y
) switch to change the
g
) and MAIN
f
) jacks.
c
)
o
)
x