JANE nurse GIRO 360 Instructions page 19

GIRO
GB
360
NOTICE
Install and use this safety seat following the instructions in this manual.
I. When using the seat as a group 0+ device, from birth up to 13 months (0-13 kg), this child safety seat
should be installed in the rear facing position.
When installed with ISOFIX and the anti-rotation strap (Top Tether), it is a "Universal" ISOFIX child
restraint system, and can be fitted on most, but not all, vehicle seats equipped with the ISOFIX system.
1. When being used for reward facing Group 1, from 9 monts to 4 years old (9-18 KGS), this baby car seat
should be installed reward-facing, being installed with ISOFIX and Top Tether, it is ISOFIX "Universal"
child restraint, and it will fit most. but not all, car seat equipped with ISOFIX system.
II. When being used for forward facing Group 1, from 9 months to 4 years old (9-18 KGS), this baby car
seat should be installed forward-facing.
1- When installed with the vehicle seat belt, the ISOFIX system is used for auxiliary devices, it is a "semi-
universal" child safety seat.
2- When installed with the vehicle seat belt, without using the ISOFIX system, it is a "universal" child
safety seat.
III. When used for groups II and III, from 3 to 12 years (15-36 kg), this safety seat should be installed in
the forward facing position.
1- When installed with the vehicle seat belt, if the ISOFIX system is also used, it is a "semi-universal"
child safety seat.
2- When installed with the vehicle seat belt, if the ISOFIX system is not used it is a "universal" child
safety seat and it can be fitted on most, but not all, vehicle seats.
If in doubt, consult the child safety seat manufacturer or the retailer.
It is only suitable if the approved vehicles are fitted with 3-point seat belts, approved by CEPE
standard 16 or other equivalent standards.
EXTREMELY DANGEROUS
This device must not be used on passenger seats fitted with airbags (SRS).
SAFETY
Do not install or use this child safety seat until you have carefully read and understood the installation
instructions provided by the manufacturer.
Do not place this child safety seat in the forward facing position on a seat fitted with an airbag.
Pay attention to the red/blue stickers or the red/blue plastic on the seat, which indicate where the
seat belt should go when installing the seat: blue for the rear facing position and red for the forward
facing position.
The straps that fasten the safety seat to the vehicle should be tight. The straps that secure the child
should be adjusted to fit the child's body and must not be twisted.
Do not leave the child unattended in the child safety seat.
Make sure that the lap belt is positioned low down, so the child's pelvis is held securely.
The child safety system should be replaced if it has been involved in an accident.
Do not make any alterations or additions to the device without the approval of the competent authority.
If the seat does not have a fabric cover, it should be kept out of direct sunlight; otherwise it may become
too hot for the child's skin.
Any luggage or other objects that could cause injury in the event of a collision must be correctly
secured.
The child safety seat should not be used without the cover.
The seat cover should not be replaced by a different one that has not been recommended by the
manufacturer, as it is integral to the performance of the child safety seat.
The instructions should be kept in the child safety seat during its useful life.
Do not use any load bearing contact point other than the one in the instructions and marked on the
child safety seat.
The rigid elements and plastic parts of the child safety seat should be fitted following these instructions
and installed so that they do not get caught in a mobile seat or in a door of the vehicle during everyday
use of the vehicle.
O
19