Oase InScenio Notice D'emploi page 19

Questions, problems, missing parts?
Before returning to your retailer, call us at 1-866-627-3435, 8 a.m.-6 p.m., EST, Monday-Friday, or email
us at customercare@oase-livingwater.com. Or visit our website at www.oase-livingwater.com
Cleaning time ʺCleaningʺ (CL)
This setting changes the duration of the cleaning cycle. If the water does not carry away all
dirt, a longer cleaning time is required. This may become necessary if, for instance, very
long drain pipes or drain pipes with many bends were installed or there is a particularly
large amount of sticky dirt (e.g. during spawning).
· A longer cleaning time increases the water consumption. The default setting of 10 s is
usually sufficient (corresponds to approx. a
How to proceed:
· Touch the button of the slider control and move it to adjust the time.
– Adjustable range: 10 – 30 s.
Extended cleaning time "Extra Cleaning" (EC)
The extended cleaning time after every 20 cleaning cycles prevents larger deposits in the
dirt channel or the pipework. This ensures that the pipework is flushed out at regular inter-
vals.
However, if dirt and residue build up due to unfavourable conditions, increase the cleaning
time to flush out the pipe with additional water.
How to proceed:
· Touch the button of the slider control and move it to adjust the time.
– Adjustable range: 10 – 60 s.
Time-dependent cleaning "Intervall" (ln)
In addition to automatic cleaning, an option for time-dependent cleaning is available. This
is particularly useful for ponds containing fish. Even if there is only a small amount of dirt,
excrement is always removed from the water cycle before it leads to a build-up of nutrients.
The time-dependent cleaning cycle does not have any influence on the automatic cleaning
cycle that starts when the water level is too low. After each automatic cleaning cycle, the
time interval is reset and starts again from the beginning.
How to proceed:
· Touch the button of the slider control and move it to adjust the time.
– Adjustable range: 0; 3 – 60 min.
– 0 minutes: The function is deactivated.
– Basic setting: 20 minutes (the ideal setting for most applications).
Basic settings
The control system is reset to the basic settings.
· All individually set values are overwritten!
· The following values are set:
– Cleaning time CL: 10 s
– Extended cleaning time EC: 20 s
– Interval of the time-dependent cleaning In: 20 min
7
/ drum rotation).
8
- EN -
19