HP StoreOnce 4900 Manuel D'installation Et De Configuration page 46

4 = eth1, eth2, eth3 (1 Gig)
5 = eth4, eth5 (10 Gig)
-->5
<--Bonding: eth4, eth5 (10 Gig)
Select the desired bonding mode :
-----------------------------------------------------------------
Note that if you select bonding mode 6, you will not subsequently
be able to add VLAN networks to this Port Set.
-----------------------------------------------------------------
1 = Mode 1 - Active Passive Bonding (default)
2 = Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
3 = Mode 6 - Active Load Balance Bonding
-->2
<--Bonding Mode: Mode 4 - Link Aggregate Control Protocol (LACP) Bonding
Is this subnet on a Virtual LAN?
1 = No (default)
2 = Yes
-->2
<--VLAN/Not VLAN: Yes
Enter VLAN tag (an integer between 2 and 4094 inclusive) :
-->22
<--VLAN Tag: 22
Select Static or DHCP addressing :
1 = DHCP (default)
2 = Static
-->2
<--DHCP/Static: Static
Enter an IP address for this network:
-->10.1.1.16
<--Static IP address: 10.1.1.16
Enter network mask or network prefix length :
For IPv4 networks, you may enter either a netmask or a length;
For IPv6 networks, you must enter a network prefix length.
-->255.255.255.0
<--Network mask/length: 255.255.255.0
-----------------------------------------------------
Note that if you intend to select this network as the
default network later on, then you must now specify
an IP address.
If, on the other hand, you do not intend to have a
default network, then you may not specify any
gateways for the system.
-----------------------------------------------------
Enter gateway IP address :
-->10.1.1.1
<--Gateway: 10.1.1.1
Enter domain name :
-->rnd.mycompany.net
<--Domain name: rnd.mycompany.net
----------------------
Network: subnet_2
----------------------
IP Addresses: 10.1.1.16
Netmask/Prefix: 255.255.255.0
Domain Name: rnd.mycompany.net
Gateway: 10.1.1.1
VLAN tag: 22
Port Set: Port Set_2 with these interfaces: eth4 eth5, Framesize: 1500
Encryption Links:
Bonding Mode: 4 (Link Aggregate Control Protocol (LACP) Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
46 Configuration réseau, comment utiliser les commandes CLI de StoreOnce