HP StoreOnce 4900 Manuel D'installation Et De Configuration page 49

----------------------
IP Addresses: 172.1.1.16
Netmask/Prefix: 255.255.0.0
Domain Name: uk.mycompany.net
Gateway: 172.1.1.1
VLAN tag:
Port Set: Port Set_3 with these interfaces: eth2 eth3, Framesize: 1500
Encryption Links:
Bonding Mode: 6 (Active Load Balance Bonding)
Is this configuration correct?
1 = Yes (default)
2 = No
-->1
<--Configuration okay: Yes
4. Vous avez désormais configuré tous les ports disponibles. L'assistant vous demande maintenant
de confirmer vos paramètres. Il validera et activera automatiquement cette configuration pour
vous si vous confirmez que les paramètres sont corrects, et qu'il n'y a aucune erreur.
-------------------------------------------------------------
If you have added all subnets, then you may proceed: you will
then be shown a summary of the configuration and be given the
option to validate it, and then a further option to apply it.
Otherwise, you may continue to add further subnets.
-------------------------------------------------------------
Do you want to configure another subnet?
1 = No (default)
2 = Yes - on a new physical port set
3 = Yes - a new IP6 subnet same physical port set
-->1
<--Another subnet: No
---------------------------------------------------------------------
If you specify at least one network gateway, you must choose a
default network from either the defined DCHP OR Static subnets
as DCHP includes both IPv4 and IPv6 gateways.
The default network must have an associated gateway.
If you do not specify any network gateways, then you may not choose
a default network.
---------------------------------------------------------------------
Select default from Static or DHCP subnets :
1 = DHCP (default)
2 = Static
-->1
<--DHCP/Static: DHCP
---------------------------------------------------------------------
If you specify at least one network gateway, you must choose a
default network from either the defined DCHP OR Static subnets
as DCHP includes both IPv4 and IPv6 gateways.
The default network must have an associated gateway.
If you do not specify any network gateways, then you may not choose
a default network.
---------------------------------------------------------------------
Select a default network (The default network shall be used as the default gateway subnet) :
1 = subnet_1 - DHCP (default)
-->1
<--Default Subnet: subnet_1 - DHCP
*Step Complete* Do you want to :
1 = Go to next step: Step 3) (default)
2 = Go back to previous step: Step 1)
3 = Go back to start of present step: Step 2)
4 = Quit wizard and lose all settings
-->1
<--Navigation: Go to next step: Step 3)
Step 3) Save and apply all network settings
-------------------------------------------
----------------------
Network Name: net_wizard
Network Description: Created by wizard on: Tue Oct 7 10:42:35 2014
Write Protected: no
DNS Servers: 172.1.1.100 172.1.2.100 2001:DB8::1
Port Sets: Port Set_1 Port Set_2 Port Set_3
----------------------
Number of Networks: 4
Number of V4 VLANs configured: 1 out of possible 128
Number of V6 VLANs configured: 1 out of possible 128
----------------------
Configuration réseau en utilisant net set wizard 49