Testing The Dtrx3 Receiver - Videotec DTRX3 Manuel D'instructions

Testing the DTRX3 receiver

After having connected the positioning device and the lens cables, to check the correct working of the devices, it is
necessary to perform the automatic test which will show the allowed functions.
WARNING! Since during this phase the positioning devices makes automatically some predetermined
movements, do not lean on during the test and do not obstruct its trajectory.
Proceed according to the following indications:
1. power the receiver on
2. identify the Up arrow-switch (P4 switch) and the reset switch (P1 switch)
3. keep pushing the Up switch and press the reset switch
4. release the reset switch (keep pushing the Up switch): the automatic test starts
5. after the starting of the test, release the Up switch
The receiver starts up one function at a time, for about 3 seconds:
•
Pan: left-right Led P
•
Tilt: low-high Led T
•
Zoom: wide-tele Led Z
•
Focus: far-near Led F
•
Iris: close-open Led I
The result of the test is shown from the 5 control leds P, T, Z, F, I (placed near the arrow-switches, see the receiver
scheme at page 7), at the end of the of the movement of the Pan&Tilt and lens:
•
led switched on and fixed: the relevant function (pan P, tilt T, zoom Z, focus F, iris I) works correctly.
•
Led switched on and blinking: the relevant function doesn't work or is not present and cannot be used for
preset/scan/patrol functions.
After some seconds from the end of the test the receiver automatically starts working.
Warning! A blinking of at least one of the leds at the end of the test (provided that this function is included)
indicates a malfunction to which you must find a remedy before the receiver starts working.
Pag. 16 MNVCDTRX301_1623_EN