Connection With The Rs232 Line - Videotec DTRX3 Manuel D'instructions

Note: from the Receiver side the connection should be made to terminals RXCL and AGND according to the following
scheme:
• if the receiver is connected in cascade to another DTRX3 unit, the reception mode should be set in Current Loop
with jumpers JP2 and JP3 in position CL.
• terminals RX CL and AGND should be connected to the preceding unit terminals TX CL and AGND respectively as
in the following scheme:

Connection with the RS232 line

RS232 Connection: max. distance 15 metres.
DCS2/DCMT8
TX RS232 Black
GND RS232 Green
DTRX3
-------- Yellow RX RS232
-------- Red GND RS232
Pag. 14 MNVCDTRX301_1623_EN