Sony TA-ZH1ES Manuel D'instructions page 29

Setting items
[AUTO VOLUME DOWN]
Turns down the volume level of the amplifier
automatically when changing the output,
inserting/removing the headphone plug,
changing the GAIN select switch setting, or
turning the amplifier on while the volume
level is set to loud.
[ANALOG IN FORMAT]
Selects the playing format of the audio signal
that is input from the LINE IN L/R jacks.
[PRE OUT]
Outputs the sound from the PRE OUT L/R
jacks.
[AUTO STANDBY]
Turns the amplifier off automatically when
you do not operate the amplifier in the silent
state for about 20 minutes.
[LR BALANCE]
Adjusts the right and left balance of the
output signal that is output from the
headphone jack or PRE OUT L/R jacks.
Setting value
[OFF]: Off
•
[ON]: On
•
Note
This function is available for the headphones level
only. The volume level for PRE OUT is not changed.
Select from the following formats.
[PCM48kHz]/[PCM96kHz]/[PCM192kHz]/
[DSD2.8MHz]/[DSD5.6MHz]/[DSD11.2MHz]
Note
The DSEE HX function works only when [PCM48kHz]
is selected.
[OFF]: Off
•
[VARIABLE]: Select this when adjusting the
•
volume level on the amplifier.
[FIXED]: Select this when adjusting the
•
volume level on the connected equipment.
The sound is output with the volume level
fixed.
Note
When you set to [OFF], [PRE OUT] is not displayed as
the output target that is selected by OUTPUT.
[OFF]: Off
•
[ON]: On
•
Note
The default setting differs depending on the area.
Adjust from the following range.
[L+6.00dB] - [CENTER] - [R+6.00dB] (0.25 dB
increments)
Tip
You can set [LR BALANCE] of the headphone jacks
and PRE OUT L/R jacks independently.
GB
29
GB