Seac Sub PRO 2000 ADV Instructions page 41

ENGLISH
Attention!
It is strictly necessary to regulate hydrostatic
balance during the ascent in order to avoid
rising too quickly. Consult with your instructor or
your diving manual for further information
concerning this necessity. Always follow the
required regulations and those dictated by your
underwater computer or your decompression
tables during each phase of diving.
Having reached the surface, you can
completely inflate the bags and remain
comfortable while waiting for your boat to
pick you up. Remember that there is no
danger of inflating the bag too much on the
surface because the overpressure valves
release excess air pressure.
If you need to attract attention, you can use
the DIN standard dual tone whistle included
(Drawing 26).
In order to remove the stabilizing jacket, you
must open the waist buckle and unfasten the
sternal buckle on your chest with two fingers,
while a simple movement on the 50 mm clips
to the right and left will separate the shoulder
straps and facilitate its removal (Drawing 27).
If the weight pockets are used, we advise,
first of all, removing them by holding the
corresponding knob and pulling hard
outwards.
Having reached a steady surface, in order to
remove your stabilizing jacket from the tank,
you must remove the hose that is connected
to the power inflator and unfasten the locking
belts for the tank.
42
Drawing 26
Dual tone whistle
Drawing 27
Releasing the clip to facilitate removal
Drawing 28
Disassembly of the overpressure valves