hestan Aspire Serie Manuel D'utilisation Et D'entretien page 16

CONTROLS AND SETTINGS
ZONE TIMER ZONE TIMER
Each zone can have its own timer set.
EN
1. Touch the ON key for the cooking zone
2. Touch the
3. When the indicator goes steady, the value is accepted.
• If more than one timer is set, the display shows the lowest value,
the one that will expire first. The timer LED (ref. 4) related to
the zone which the displayed value is referring to, is flashing. If the
displayed value refers to the independent timer, the timer LED (Figure
11 ref. 2) flashes.
• To check the remaining time for any one of the timed zone, touch the [ON] key related to the
zone: the corresponding timer LED will begin to flash and the value on the timer display will
switch for some seconds to the new value. After a time-out, it will switch back to the shortest
one.
WHEN THE TIMER VALUE ELAPSES: WHEN THE TIMER VALUE ELAPSES:
An end of activity beep sequence sounds: three short beeps followed by a long interval are repeated
for 1 minute.
The LED indicator related to the elapsed timer flashes.
The timer value "00" flashes too and will continue to flash waiting for a user confirmation.
• Touch or
+ +
blank if there is no other timer set.
NOTICE
Timers have no effect on the heating elements. The cooking zone must always be stopped manually
by touching the related [OFF] key.
RESIDUAL HEAT RESIDUAL HEAT
The HOT SURFACE indicators remain on even after the end of the cooking activity, for enough time
to let the surface cool down to a safe level.
The residual heat time depends on the power level that was set on the
cooking zone and the time the heating element has been working for.
For example, a cooking zone that has been working for more than 5
minutes at full power will take half an hour to cool down before the
Residual Heat indication fades away. At level 1 it will take about 10
minutes.
OVERTEMPERATURE PROTECTION OVERTEMPERATURE PROTECTION
The control monitors its own internal temperature and stops any activity in
case of overheating of inner parts. The display will show
Let the appliance cool down.
14
©2020 Hestan Commercial Corporation
or keys to activate the timer and set the value.
+ + − −
to cancel the expired timer, the display switches to the next shortest timer or becomes
− −
The timer is only intended as an acoustic advisor to recall the attention of the
user.
(CONTINUED)
if this occurs.
4
TIME
Figure 12.
TIME
3
Figure 13.