Independent Timer - hestan Aspire Serie Manuel D'utilisation Et D'entretien

CONTROLS AND SETTINGS
EXITING BRIDGE MODE EXITING BRIDGE MODE
To stop "Bridge Mode", use either zone's selector key to turn the zones off. This will stop "Bridge
Mode".
ZONE ACTIVE / HOT SURFACE INDICATORS ZONE ACTIVE / HOT SURFACE INDICATORS
Each zone has a "Hot Surface" indicator light to show that the zone's surface is hot.
When a zone is activated, the light turns on, and it remains until the zone is deactivated and the
surface has cooled to a "safe to touch" temperature (approximately 150° F).
RAPID BOIL FUNCTION RAPID BOIL FUNCTION
This function sets a zone to heat at full power (power level 9) for ten minutes, then it drops to the
set power. It is available for any zones, including bridged or double/triple zones.
To enable Rapid Boil: Select a zone and touch RAPID BOIL. You can set power before or after
selecting Rapid Boil.
The power indicator for the selected zone will alternate between "P" and the set power level.
KEY LOCK FUNCTION KEY LOCK FUNCTION
The LOCK function disables all control functions except "Select/Zone OFF" and ON/OFF (all off).
To lock/unlock, touch the LOCK key for two seconds. The indicator light is ON when the controls
are locked.
TIMERS TIMERS
There is one timer for each cooking zone, plus an independent timer.
NOTE: Timers are simply reminders - they do not control elements or turn them off.

INDEPENDENT TIMER

INDEPENDENT TIMER
1. Make sure no zone is flashing/waiting for input
2. Touch the or keys to activate the timer and set the value. The maximum value is 99.
+ + − −
3. To cancel the timer, either use the
to zero the timer.
To check the independent timer value when it's not displayed with the highest priority, touch
or when no zones are selected. The timer LED (ref. 2) flashes and the displayed value switches to
− −
the independent timer.
(CONTINUED)
or keys to set the time to zero, or touch them both at once
+ + − −
2
1
-
+
Figure 11.
©2020 Hestan Commercial Corporation
EN
+ +
3
13