Controls And Settings; Switching The Control On - hestan Aspire Serie Manuel D'utilisation Et D'entretien

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

CONTROLS AND SETTINGS

USING THE CONTROL
USING THE CONTROL
When the cooktop is connected to the electrical
voltage supply all lights and digits turn on to
indicate a proper activation. This operation will
be completed after a few seconds, the control
turns off automatically. Then the cooktop is
ready for operations.

SWITCHING THE CONTROL ON

SWITCHING THE CONTROL ON
If the commands are locked, touch the [LOCK]
key for a few seconds. (See that the LOCK LED
is on and turns off after a few seconds.)
Touch the main ON/OFF key to enable the
single zones for selection.
All the displays show power level "0". If you
don't touch anything else, the control shuts
down again after about 10 seconds.
SELECTING AND SETTING ZONE POWER
SELECTING AND SETTING ZONE POWER
Touch the ON key for the desired zone: the HOT SURFACE
(ref. 3) indication starts flashing, waiting for user input.
Touch the slide bar to set the power level (levels 0 to 9). You
can slide your finger along the bar to select the desired value.
The display (Figure 7 ref. 4) and the "Peacock Tail" (Figure 8
ref. 6) shows the power level, updated in real time.
After a 5 seconds time-out the value is accepted and the HOT
SURFACE indicator (Figure 7 ref. 3) stops flashing.
The "Peacock Tail" disappears after some seconds more.
The following picture represents the Full Power Scale
where the control uses all the available power range from
0% up to the 100% corresponding to level 9.
Level 4 corresponds to 15% of the available power.
NOTICE
This touch control works using optical light
sensing technology.
When first connecting electrically, or after
a power failure, any direct strong light over
the sensor area may affect the touch control
functionality.
When powering on the unit make sure that no
strong light is shining directly over the touch
control zone, it can compromise the start-up
sensor calibration resulting in an unresponsive
touch control.
6
2
6
7
Figure 8.
©2020 Hestan Commercial Corporation
5
4
1
3
Figure 7.
11
EN

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Kec serieKec30-bkKec36-bk

Table des Matières