hestan Aspire Serie Manuel D'utilisation Et D'entretien page 14

CONTROLS AND SETTINGS
USING SIMMER USING SIMMER
SIMMER is a low temperature mode, where a level
of 9 in SIMMER has the same power as a level of 4 in
EN
normal mode, 15% of full power.
Select a cooking zone, then touch the SIMMER key
(ref. 8) to enable simmer mode, then set power with
the slider. In SIMMER mode, the inner numbers of the
power scale (ref. 9) show selected power.
RETURNING TO NORMAL MODE RETURNING TO NORMAL MODE
Select the zone and touch the SIMMER key again to
return to normal mode.
NOTE: The numeric power value stays the same, so
the power will increase to the normal amount for that
power level.
When a zone is turned off, the SIMMER mode is halted for that
zone as well.
TURNING A ZONE OFF TURNING A ZONE OFF
Touch the zone's OFF key to turn an active zone off.
To turn all zones off, touch the main ON/OFF key.
USING A DUAL ELEMENT ZONE USING A DUAL ELEMENT ZONE
The 30" cooktop has a dual element zone (see page 7).
To use the smaller part of the zone (inner element) , touch the selector (ON) key and set a power
level.
To select/deselect the outer element of the zone, touch the ON key and then touch the DOUBLE
key. The DOUBLE indicator will illuminate when both (inner and outer) elements are selected.
USING A TRIPLE ELEMENT ZONE USING A TRIPLE ELEMENT ZONE
The 30" and 36" cooktops have a triple element zone (see page 7).
To use the smallest part of the zone (inner element) , touch the selector (ON) key and set a power
level.
To use the inner and middle elements, touch the TRIPLE key while the HOT SURFACE indicator is
flashing. The the DUAL indicator (Figure 8 ref 5) will illuminate when the inner and middle elements
are selected.
To use the third element as well (entire zone), touch the TRIPLE key again. The TRIPLE indicator
will illuminate when the entire zone (inner, middle, and outer elements) is selected.
USING BRIDGE MODE USING BRIDGE MODE
The 36" cooktop can use the two left cooking zones and a special
element between them all together in "Bridge Mode".
1. Touch the ON key for either of the left two zones.
2. Touch the BRIDGE key. The extension indicators (ref 6a, 6b) will
turn on.)
3. Set power using the slider. Both zones will show the set power.
• Both of the left cooking zones and the bridge element are
controlled together while bridged.
• Either zone's OFF key will turn the entire bridged zone OFF.
12
©2020 Hestan Commercial Corporation
(CONTINUED)
9
8
Figure 9.
6b
6a
BRIDGE
3
Figure 10.
3