KTM TOURATECH TOP CASE Mode D'emploi page 31

Tip
It is recommended that you note the numbers of
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
–
Repeat the steps for chambers
first six chambers are fitted with the correct tumblers.
–
Insert the key.
All tumblers must close flush with the locking cylin-
der.
500518-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown (engaging
bo
plate
Engaging plate
500646-01
–
Pull up the locking lever.
–
Position locking plate
der as shown.
The plate faces to the right.
–
Mount and tighten screw
ded).
Info
The locking plates with notch
500647-01
needed for the cover's optional lock installation, see
Section 7
–
Key position 90° to the left to open.
–
Key position upward for locking.
500648-01
B D
,
bn
(included).
p. 17)
must be facing downward).
bo
engages.
2
(included) on the locking cylin-
4
with washer
3
ASSEMBLY 5
F
, and until the
5
(both inclu-
(included) are
11